CLI means command line interface. Go here and scoll down till you see your model number, there is the user guide of the CLI:
http://www.speedtouch.com/support.htm

__________________

"Never Argue With An Idiot. They Will Drag You Down To Their Level, Then Beat You With Experience"

is this what i should do http://www.speedtouch.com/documentat...cli&topic=init ive been on firewall comands shall i go on firewall clear or firewall config

thank you so much

I'd say you use this one:

firewall config

Configure the firewall options.
SYNTAX:

firewall config


[state = <{disabled | enabled}>]

[keep = <{disabled | enabled}>]

[tcpchecks = <{none | fast | exact}>]

[udpchecks = <{disabled|enabled}>]

[icmpchecks = <{disabled | enabled}>]

[logdefault = <{disabled | enabled}>]

[logthreshold = <{disabled | enabled}>]

[tcpwindow = <number{0-1073725440}>]

where:

state

Enable or disable the firewall.

The default is enabled.

__________________

"Never Argue With An Idiot. They Will Drag You Down To Their Level, Then Beat You With Experience"

hi again sorry to be such a pain but where do i add that code thing.
soryy about the questions
thankss

Honestly, I've no idea......
What I could imagine is that you either need to use the "Tab" of your keyboard to switch from enabled to disabled, or the arrows of your keyboard or even maybe a manual input of the words......

__________________

"Never Argue With An Idiot. They Will Drag You Down To Their Level, Then Beat You With Experience"

Another option I've just thought about would be to check whether UPnP is enabled in the router instead of disabling the firewall switch to "full":

upnp config

Configure the UPnP™ parameter(s).
SYNTAX:

upnp config


[maxage = <number{60-999999}>]

[writemode = <{full | natonly | readonly}>]

[safenat = <{disabled | enabled}>]

[preferredaddress = <ip-address>]

[httpport = <number{1-65535}>]

where:

maxage


A number between 60 and 999999.

This parameter allows to configure how often the SpeedTouch™ sends a notification message to advertise its presence as an Internet Gateway Device (IGD) on the network.

The default is 1800.
Note Setting this parameter to a low value will increase the number of packets sent over time on the network, but will make the state of the device more up to date.


OPTIONAL

writemode


Choose the set of rules to limit remote access from UPnP.

Choose between:



full: the host will accept all the UPnP SET and GET actions.



natonly: GET and NAT related SET actions will be accepted, all other actions will be ignored.



readonly: the UPnP control point will only be able to retrieve information, all the SET actions are ignored.

The default is natonly.


OPTIONAL

safenat


Enable or disable check on safe NAT entries.

If this check is enabled, all NAT create/delete requests for a LAN side IP address different from the source IP address of the UPnP message will be discarded.

The default is enabled.


OPTIONAL

preferredaddress


CSV list of preferred IP address for UPnP advertisements (1 per LAN IP interface).
Note Enter “0.0.0.0” for none.


OPTIONAL

httpport


A number between 1 and 65535.

Represents the web server port.

The default is 80.

__________________

"Never Argue With An Idiot. They Will Drag You Down To Their Level, Then Beat You With Experience"

ive managed to disable the firewall properly, but i can still see the brick wall next to the globe