I presume your outgoing ip is either 192.xxx or 10.xxx right? Have you tried the proxy settings in LW? I'm not in the know about connecting from a large network domain. Are you saying the IT guy at work is able to use LW at work? If yes, then there's perhaps something he isn't telling you.

yeah, I've fussed with the ip settings in LW. Mumbo Jumbo. All that crap is confusing. I've gone into LW, and told it to use an Http proxy, and input the proxy and gate I've been using. Now, it doesn't want to work. You are right about the IP address though. 192.xxx.x.xxx.....

The IT guy does not run Lime Wire. He's a nerd, and doesn't even know what it is. The thing is, I was running it just fine, before. He has not changed anything, and I've always had a 192 IP address. There is a domain, that all the OTHER computers are hooked into. I am NOT part of the domain, but we all share the same connection.

Did you check whether the IP address and the Mask in LW are the same in the Local Area Connection under TCP/IP Internet Protocol?

__________________

"Never Argue With An Idiot. They Will Drag You Down To Their Level, Then Beat You With Experience"

I can easily find these values in Windows, but I don't know where i would find them in LW.

Maybe I'm not following. Are you saying that I should compare the IP and subnet values in my windows settings to the values in LW? If so, I don't know where to find them in LW.

I know that under options>advanced>proxy I have it set to use an Http Proxy with the proxy address and port input into the fields. I don't know where I would specify the IP address or Subnet Mask values.

FYI: I also have it set on Manual Port Forward on 6346 and to listen on port 5722. (I don't know if that makes a difference).

Yes it makes a difference AFAIK. The manual portforward number should be the same as the listening port.

Yeah and I mistook the IP settings with the Http settings....
Though your firewall should be configured with TCP and UDP in accurance with the listening port (and the manual port forward).

__________________

"Never Argue With An Idiot. They Will Drag You Down To Their Level, Then Beat You With Experience"

Ok, so should I change the listening port value, or the manual port forward value?

I followed instruction in one of these threads, that instructed me to do some kind of crap with the firewall port configurations. I don't think there should be an issue there, but i don't know.

The default port of LW is 6346, so both (listening and manual port forward) should be the same.
As for the firewall, it can have an effect if it is not configured properly.
Right-click you Network Connection, which should be the Local Area Connection, then go to Properties and in the General Tab you click on the Internet Protocol (TCP/IP) and then Properties. There you should check whether the IP and Submask is the same as the ones you have, if they aren't type in the ones you have.
Then go to Advanced>Settings and add the listening port 6346 as TCP once and then as UDP once and then click okay. Could be that you have to reconnect to the internet. See if that changes something.
Oh, almost forgot,....after you changed the manual port and the listening port to the same number, close LW and then follow the steps above.

__________________

"Never Argue With An Idiot. They Will Drag You Down To Their Level, Then Beat You With Experience"