Gnutella Forums - Program launch difficulty

Gnutella Forums (https://www.gnutellaforums.com/)

- General Mac Support (https://www.gnutellaforums.com/general-mac-support/)

- - Program launch difficulty (https://www.gnutellaforums.com/general-mac-support/21783-program-launch-difficulty.html)

Program launch difficulty

I just upgraded to the most recent release of LW for Mac. I am running 9.2.2 environment with VM. Upon downloading the 10MB installer, I uninstalled the previous version, searched the computer for all traces of the program, deleted all the prior accessories, alias', and etc.
I installed the program to a storage drive, in virtually the same place/environment that the prior version had been in, and I can't launch the program--at all.
I get the wrench logo thing, then the Mac stops it and says that Limewire has unexpectedly quit due to an error of "type 1" occuring...
Any idea what's going on?
S.

Here's what the little old "Apple Error Codes '98" says

Quote:

Error Codes 1-30

ID=01 Bus Error
This means the computer tried to access memory that doesn't exist. You can get this error on almost any Macintosh. If one of these computers tried to access one or more bytes beyond the total number of bytes in RAM, you see a bus error. You should never see this error on a Macintosh Plus or SE, because address references that are out of bounds "roll over". This means if one of these computers tries to access one byte beyond the total bytes in RAM, it actually accesses the first byte in memory. If you see this error on a Macintosh Plus or SE, it's reporting the wrong error or having hardware problems.

Sounds like a problem with a RAM chip or, hopefully, virtual memory. Maybe your memory control panel can give you more ideas. Too, try installing from the same volume/partition as the system